Silvercrest SHLF 2000 A1 Bedienungsanleitung PDF herunterladen (Seite 47)

SHLF 2000 A1 45

6.4 Setting the heat output

1. Select a heat setting to activate the

appliance. To do this, press the function

selector 11 or 23 repeatedly until the

required heat setting appears in the

display 10 as follows:

–Low heat. The appliance

operates at 1000 watts

–High heat. The appliance

operates at 2000 watts

–Automatic mode. The appliance

automatically adjusts the heat

output to the room temperature.

2. To deactivate the appliance, press the

function selector 11 or 23 repeatedly

until the top line of the display 10

disappears.

After running on for a few seconds, the

appliance switches to standby mode.

Note: The appliance continues to

consume power in this state.

6.5 Selecting the temperature

Using the “Increase temperature” button 12

or 20 you can increase the required

temperature to a maximum of 38 °C. Using

the “Reduce temperature” button 13 or 22

you can reduce the required temperature to

a minimum of 6 °C.

The selected required temperature is shown

in the display 10.

The room temperature is measured by the

temperature sensor 7.

The appliance switches off as soon as the

room reaches the required temperature. If

the room temperature falls below the

required temperature, the appliance

switches on again automatically.

6.6 Setting the operating time

The appliance has a timer with

which you can set the required

operating time. The appliance

switches off automatically once the

operating time has expired.

1. Press the “H” button 16 or 25 to set the

hours.

2. Press the “M” button 15 or 24 to set the

minutes.

Note: If you press and hold the buttons, the

values will continue to run until you release

the button again.

The selected operating time is shown in the

display 10.

6.7 Swivel function

The appliance has a swivel function.

This causes the appliance to swivel to and

fro, distributing the exiting air more evenly

through the room:

1. To switch the swivel function on, press

the swivel function button 17 or 21.

2. To switch the swivel function off, press

the swivel function button 17 or 21

again.

6.8 Thermal cut-out

For your safety the appliance has a thermal

cut-out.

If the temperature inside the appliance

becomes too high, the appliance switches off

automatically:

1. Switch the mains switch 8 to 0 to switch

off the appliance.

2. Check whether the air inlet or outlet is

obstructed and remove the cause.

If you cannot establish a cause and the

fault occurs repeatedly, have the

RP74284 HL mit FB LB5 Seite 45 Freitag, 25. Mai 2012 3:28 15

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare