Silvercrest SHLF 2000 A1 Bedienungsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 78
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
SHLF 2000 A1
7
4. Unpacking, setting up and inserting the battery
4.1 Setting up the appliance
Note!
As the appliance and heating coils
are supplied with a thin film of grease, there
might be a
small
amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack the appliance from the
packaging.
2. Remove the transport packaging.
Note:
There is a piece of corrugated
cardboard positioned between the
appliance and the base
9
. This must also
be removed.
3. Check that the appliance shows no signs
of damage.
Warning!
Ensure that there is suf-
ficient distance from the wall, fix-
tures and other appliances. The
distance must be at least 1.5 m to
exclude the risk of fire.
4. Select a location that complies with the
safety information (see “3. Safety infor-
mation” on page 4).
5. Select a location where the flow of hot
air is not directly aimed at people, ani-
mals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note:
The appliance consumes up to
10 amperes of current. If you have plug-
ged other power consumers into the
same circuit, check that the maximum
load for the installed fuse is not excee-
ded, as otherwise the fuse will trip.
4.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press the catch
towards the
middle and pull
out the battery
compartment.
2. Remove the old
battery if present.
Note:
Please observe the instructions for
disposal (see “8.2 Disposable/recharge-
able batteries” on page 11).
3. Insert a new battery.
Note:
Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery com-
partment.
4. Slide the battery compartment back in
again.
RP53439 HL mit FB LB4 Seite 7 Dienstag, 13. Juli 2010 3:13 15
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 77 78

Kommentare zu diesen Handbüchern

Keine Kommentare