Silvercrest SHBS 600 A1 Bedienungsanleitung PDF herunterladen (Seite 55)

SHBS 600 A1

Cleaning and care

DANGER

Danger to life due to electric shock!

► Pull the mains power adapter

out of the power socket before cleaning

the appliance.

► Never touch the mains power adapter

with wet hands, especially when

plugging it in or unplugging it.

► Always keep the mains power adapter

and the cable dry.

CAUTION

Possible damage to the appliance.

► The hair and beard trimmer should never be immersed in water or other

liquids for cleaning, as the appliance is not waterproof. Doing this may

damage live parts (batteries).

► Do not use aggressive or abrasive cleaning agents, as these may corrode

the surface of the casing.

► Clean the housing only with a soft damp cloth and a mild detergent.

♦ Switch the hair and beard trimmer oﬀ by pressing the ON/OFF switch

♦ Disconnect the cable from the appliance and pull the mains power adapter

out of the power socket.

♦ Remove any cutting length attachment (

) from the appliance.

♦ Wash the cutting length attachment (

) under running water if required.

♦ Dry the cutting length attachment (

) thoroughly afterwards.

♦ Push the slide switch for the thinner attachment

right as far as the stop to posi-

tion 0 to move the thinner attachment

into its starting position.

♦ Press your thumb against the front of the cutting unit to release it from its

holder (see Fig. D). Then remove the cutting unit from the appliance.

♦ Use the cleaning brush supplied to remove any residual hair from the cutting

unit .

♦ Once you have completed cleaning, push the tab of the cutting unit into the

mounting opening on the appliance (see Fig. E).

♦ Push the cutting unit back onto the appliance by pressing lightly from above until

it clicks into place (see Fig. F).

IB_102827_SHBS600A1_LB5.indb 52 23.10.14 12:18

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 73 74

Keine Kommentare

Silvercrest SHBS 600 A1 Bedienungsanleitung Seite 55